Cantilever Beam Static and Dynamic Response Comparison with Mid-Point Bending for Thin MDF composite Panels

Abstract

A new cantilever beam apparatus has been developed to measure static and vibrational properties of small and thin samples of wood or composite panels. The apparatus applies a known displacement to a cantilever beam, measures its static load, then releases it into its natural first mode of transverse vibration. Free vibrational tip displacements as a function of time were recorded. This paper compares the test results from the cantilever beam static bending and vibration with standard midpoint simply supported bending samples. Medium density fiberboard panels were obtained from four different commercial sources. Comparisons were made using a set of fiberboard panels with thicknesses of 8.1, 4.5, 3.7, and 2.6 mm and nominal densities of 700, 770, 780, and 830 kg/m³, respectively. Cantilever beam static modulus and dynamic modulus of elasticity linearly correlated well but were consistently higher than standard mid-point bending modulus of elasticity having linear correlations of 1.12:1 and 1.26:1, respectively. The higher strain rates of both the static and vibrating cantilever beam could be the primary reason for the slightly higher dynamic modulus values. The log decrement of the displacement was also used to calculate the damping ratio for the cantilever beam. As expected, damping ratio had a slightly decreasing slope as density increased. This paper discusses the new apparatus and initial results.

Keywords

Cantilever beam, Damping ratio, Dynamic modulus, Free-vibration, Static bending, Wood composite panels

Citation

Hunt, John F.; Zhang, Houjiang; Guo, Zhiren; Fu, Feng. 2013. Cantilever beam static and dynamic response comparison with mid-point bending for thin MDF composite panels. BioResources. 8(1): 115-129.